Reinforced Nozzle

用法例句

Failure Analysis of the Reinforced Nozzles of the Coil of a Reactor and lts lmprovements;

反应器盘管加强接头失效分析及改进

The influences of welding heat input on joint strength were analyzed.

采用钨极氩弧焊的方法对30%SiCP/LD2高体积分数复合材料进行了焊接实验,研究了在同种TIG焊焊接规范参数下LD2-LD2、LD2-30%SiCP/LD2、30%SiCP/LD2-30%SiCP/LD2三种不同材料组合焊接性差异,分析了焊接热输入对接头强度的影响。

The experimental results show that for industrial purity Ti and Ti 6Al 4V, respectively, the overlap brazing joint strength are 418.

结果表明:用Ti-Cu-Ni钎料钎焊TA2和Ti-6Al-4V钛合金的搭接接头强度分别是418。

The temperature and time range of brazing through the wetting experiment were confirmed, and the effect of brazing conditions on the joint strength through the shear experiment was discussed.

通过对钎料润湿性的研究确定钎焊试验的温度和时间范围 ;通过剪切试验研究了钎焊工艺参数对接头强度的影响。

Effect of interfacial microstructure of TiAl/40Cr diffusion bonding on strength of joint;

TiAl/40Cr钢扩散连接界面组织结构对接头强度的影响

Influences of adherent thickness,temperature and velocity on strength of adhesively-bonded single-lap joints

板厚、温度和速度对单搭接胶接接头强度的影响

Study on Influence of Welding Process Parameters on Strength of Welded Joint

焊接工艺参数对焊接接头强度的影响研究

measuring method for strength of mechanical fastenings for conveyer belts

输送带机械接头强度的测定

Affect of Different Solder on Intension of Cu/W Brazing Joint

不同焊料对Cu/W钎焊接头强度的影响

Ultrasoinc Nondestructive Characterization of Strength and Environmental Degradation of Adhesive Joints;

胶接接头强度及环境退化的超声波无损定征

Influence of Interlayer's Thickness on Strength of HIP Diffusion Bonding Joints Between P/M TC4 Alloy and GCr15 Bearing Steel

中间层厚度对P/M TC4-GCr15扩散焊接头强度的影响

STUDY ON BRAZING PROCESS AND JOINT STRENGTH OF ALUMINAC CERAMICS

氧化铝陶瓷钎焊工艺与接头强度的研究

Analysis of Static Strength for Overlap Joint Plates and Others;

搭接焊接头搭板的静强度分析及其它

The Strength and Loading Capacity of SSAW Pipe Welding Joint

螺旋焊管焊接接头的强度和承载能力

Effect of Recessed Bonding on Stress Distribution and Strength of Adhesively Bonded Joints

间隙连接对胶接接头应力分布和强度的影响

High strength joint bolts and nuts for rails

GB/T5098-1985钢轨用高强度接头螺栓、螺母

Shear strength and fracture surface analysis of BiAgNiCuGe/Cujoint

BiAgNiCuGe/Cu接头抗剪强度与断口分析

Adhesives--Determination of tensile strength of butt joints

GB/T6329-1996胶粘剂对接接头拉伸强度的测定

Study of the Strength and Tightness of Tube-to-Tubesheet Connection Joints;

管子与管板连接接头的强度和密封性能研究

The Deformation Behaviors and the Strength of Welded Joints with Mechanical Properties Mismatch;

力学性能失配焊接接头的强度及变形行为

Research on Fracture Behavior of Ultra-High Strength Steel and Welded Joint

超高强度钢及其焊接接头的断裂行为研究

Numerical Simulation of T-welding Residual Stress and Strength Analysis

T型接头焊接残余应力数值模拟及强度分析

Finite Element Analysis on Lame Wave Evaluating Cohesion Strength In Adhesively-bonded Joint

兰姆波评价胶接接头内聚强度的有限元分析