alloyage

用法例句

Influence of property of self-fusible alloy powders on coating microstructure;

自熔合金粉末性能对喷焊涂层组织的影响

Investigation on argon arc cladding technology of Ni-based self-fluxing alloy;

氩弧熔覆镍基自熔合金的工艺研究

Chemical composition, physical properties, microstructure and hardness of the manufactured Fe-Ni-RE self-fluxing alloy coating have been investigated and compared with Ni60 alloy, Although the Fe-Ni-RE self-fluxing alloy powder contained higher Fe and lower Ni and Co contents, than Ni 60 alloy whose main properties were at the same level.

对自行研制的Fe-Ni-RE高耐磨自熔合金涂层的化学成分、物理性能、组织和硬度等进行了研究,并与Ni60合金进行了对比,Fe-Ni-RE中铁含量虽高,但主要性能与Ni60相当,且节约了大量的镍和钴贵重元素,降低了合金原材料和生产的成本。

Design and properties of Bi-Sn-In ternary fusible alloys;

Bi-Sn-In控温易熔合金的设计与性能

Temperature-dependent fuse is one of the important parts in (smoke) fire dampers, and the fusible alloy is the key element of the fuse.

本试验研制的高温、低温两种易熔合金 ,焊接性能良好 ,在 2 kg弹簧压力下 ,分别于 70°C和 2 80°C熔断 ,完全符合 (排烟 )防火阀的标准要

Fusible alloys are the alloys with the melting point below 232°C (meltingpoint of Tin), and normally composed by bismuth, lead, tin, and indium elementsin different proportions depending on the desired properties.

易熔合金,是指熔点低于232℃(Sn的熔点)的低熔点合金;通常由Bi、Sn、Pb、In等低熔点金属元素组成。

The calculation results showed that although the activity of Si-Ca alloy confirms fairly with measured data, the activity curves of Si-Ca and Si-Ba alloy melts show relatively great negative deviation from the idea melt.

根据Miedema二元合金生成热模型,结合相关热力学数据,对硅钙钡系中的每个二元合金在1623K下的活度进行计算·结果表明,采用该模型对Si Ca合金活度的计算结果与实测结果吻合较好,Si Ca合金与Si Ba合金计算结果相对于理想熔体有较大负偏差,说明Ca及Ba原子与Si原子都有很强的相互作用,Ba Ca合金熔体在整个成分范围内较为接近理想熔体,Ca原子与Ba原子相互作用不大

According to the Miedema formation heat model and retated thermodynamic data, the activity of Si-Ca binary alloy melt at 1 623 K was calculated.

根据Miedema二元合金生成热模型,结合相关热力学数据,对Si-Ca二元合金熔体在1623K时的组元活度进行了计算,计算结果与实测结果吻合较好。

The electromagnetic separation of Si phase from (Al-Si) alloy melt been in vertical, incline and horizontal states were investigated experimentally in high frequency electromagnetic field.

本文针对高频电磁场对处于垂直、倾斜和水平状态下的(Al-Si)合金熔体中的硅相从合金熔体中的电磁分离过程进行了实验研究。

Research on RE Micro-alloy Effect in Self-fusion Alloy;

RE在自熔合金中微合金化作用的研究

Study on High-hardness Nickel-based Self-fluxing Alloy Coating Remelted by High Frequency Induction Remelting

高硬度镍基自熔合金涂层高频感应重熔研究

Metallic powder material--Self-fluxing Fe-Cr-B-Si alloy powder

GB/T8549-1987Fe-Cr-B-Si系自熔合金粉

Metallic powder material--Self-fluxing Ni-B-Si alloy powder

GB/T5315-1985Ni-B-Si系自熔合金粉

Metallic powder material--Self-fluxing Ni-Cr-B-Si alloy powder

GB/T5316-1985Ni-Cr-B-Si系自熔合金粉

Thermal spraying--Self-fluxing alloy coatings

GB/T16744-1997热喷涂自熔合金涂层

Study on the Property of Cavitation Erosion of Nickel-based Self-fluxing Alloy Ni67

镍基自熔合金Ni67的空蚀磨损特性研究

Study on Microstructure of Ni-based Alloy;

镍基自熔合金复合材料界面微观结构研究

Effect of RE on Microstructure and Properties of Nickel-based Self-fluxing Alloy Coating by Vacuum Fusion

稀土对镍基自熔合金真空熔结涂层组织和性能的影响

Effect of magnetic field parameters on properties and microstructure of Fe5 overlay deposit

磁场参数对Fe5自熔合金性能及显微组织的影响

Laser Cladding and Laser-induced Self-propagating Synthesis of Zr-based Amorphous Alloys;

Zr基非晶合金激光熔覆与诱导自蔓延合成

Research on Microstructure and Performance of High Hardness Ni-based Self-Fluxing Alloy after Flame Remelting

火焰重熔高硬度镍基自熔性合金组织及性能研究

Sprayed-on Self-Fusible Alloys Assure Much Longer Service Life of Expendable Parts

大幅度提高易损件寿命的喷焊自熔性合金

Study on Feeding Process in CEVM of Titanium and Titanium Alloy

钛及钛合金真空自耗熔炼补缩工艺研究

The melting microstructure and properties of Ni-graphite self-lubricating alloys

Ni基合金-石墨自润滑材料的熔炼组织及性能

A eutectic mixture, solution, or alloy.

低共熔混合物，易熔质易熔的混合物，溶体或合金

any low-fusing alloy used in cheoplasty (molding artificial teeth).

低熔点合金，用于低熔铸型（假牙成型）。

a fusible bismuth-base alloy; melts at about 160 degrees Fahrenheit.

可熔的铋基合金，在华氏度熔化。