cyclic viscosity

用法例句

Design in the white-water and the binder circulation system of glass fiber tissue plant;

玻璃纤维湿法薄毡生产线白水、粘结剂循环系统的开发

Study on improvement of cycle performance of spinel LiMn_2O_4;

提高尖晶石LiMn_2O_4循环性能的研究

Effect of degree of crystallization on the cycle performance of spinel LiMn_2O_4

结晶度对尖晶石LiMn_2O_4循环性能的影响

The content of conductive additive also has an influence on the cycle performance.

此外,混料前对导电剂进行一些表面处理也能明显改善电池的循环性能。

Comparing this model with the Bodner-partom's model,it has been found that the new model is more reasonable indescribing the experimental phenomena of instantaneous plasticity, cyclic plasticity and creep deformation(in-cluding stress relaxation and creep recovery)of engineering materials.

重点考察了该模型对工程材料三种基本变形过程的描述能力：（１）瞬时塑性。

Fatigue crack growth threshold is predicted based on material s cyclic plasticity.

基于材料的循环塑性预测了疲劳裂纹扩展的门槛值。

The result showed that the low-cycle fatigue cycle characteristic of the material is cyclic softening under the experimental condition and the softening velocity increases with the increasing of strain amplitude.

对利用驰豫-析出-控制相变(TMCP+RPC工艺)技术获得的800MPa级超细晶粒低合金高强度钢的低周疲劳性能进行了测试,并对其循环特性和疲劳断口进行了观察和分析,发现该材料为循环软化,而且随着应变幅的提高,材料的软化速率逐渐增大。

Analysis of cycle characteristics of 9Ni steel showed that,for all three kinds of heat treatment,there was no obvious cyclic softening phenomenon or cyclic hardening phenomenon at low strain amplitude;however, the fatigue cyclic characteristics of 9Ni steel were all cyclic softening at high strain amplitude,and in which it was most serious for QT1.

通过对循环特性的分析发现,三种热处理制度下,9Ni钢在低应变幅下都未表现出明显的循环软化或循环硬化现象;而在高应变幅下均表现为循环软化,其中热处理制度QT1循环软化最为严重。

Film Formation and Cycleability of LiBOB-Based Electrolyte

LiBOB基电解液成膜性及其循环性能

OPTIMAL PERFORMANCE CHARACTERISITICS OF THE REGENERATIVE FERROMAGNETIC ERICSSON REFRIGERATION CYCLE

铁磁回热Ericsson制冷循环性能特性优化

The Thermodynamic Analysis of a Quantum Ericsson Cycle Performance

量子埃里克森循环性能的热力学分析

Optimal Analysis on the Performance of Two Kinds of Irreversible Refrigeration Cycles;

两种不可逆制冷循环性能的优化分析

Analysis of the Cyclic Performance of R22 and Investigation on Its Substituting Refrigerants;

R22循环性能分析及其替代工质研究

Optimal Analysis on the Performance of an Irreversible Harmonic Quantum Refrigeration Cycle;

谐振子量子制冷循环性能的优化分析

Study on operating mode cycle performance of lithium ion power battery with natural graphite and LiFePO_4

磷酸铁锂动力电池工况循环性能研究

The Cycle and Performance Analysis for Two-stage Absorption Heat Pump Type-Ⅱ

Ⅱ型两级吸收式热泵循环及性能分析

Optimal Performance of a Parmagnetic Ericsson Refrigeration Cycle

顺磁质埃里克森制冷循环的优化性能

Performance analysis of reverse-Brayton air refrigerator

逆布雷顿循环空气制冷机的性能分析

THE PERFORMANCE ANALYSIS OF A BRAYTON REFRIGERATION CYCLE WORKING WITH A FERMI GAS

费米气体布雷顿制冷循环的性能分析

The Performance Analysis of a Brayton Cycle of an Ideal Bose Gas

理想玻色气体布雷顿循环的性能分析

Performance of the Gaslift Self-Circulation (GSC) Reactor;

气升式自循环厌氧反应器性能的研究

Study of Inhibiting Corrosion Performance for Molybdate in Industrial Cyclic Cooling Water;

工业循环冷却水钼酸盐缓蚀性能研究

Study of Non-Flowing Zinc-Bromine Battery and Its Charge and Dicharge Performance;

非循环Zn-Br电池及其充放电性能研究

Development of On-line Thermoeconomic Calculation of Combined Cycle Power Plants;

联合循环电站在线性能计算软件开发

Dynamic Behavior Analysis of Soft Clay under the Cyclic Loading;

循环荷载作用下软土的动力性能分析

Study on the Cyclic Voltammetry of LiCo_(1-X)M_XO_2;

LiCo_(1-X)M_XO_2的循环伏安性能研究