master cylinder head end bearing

用法例句

Development of a main bearing cap for an inline 6 cylinder engine;

一种直列式6缸发动机主轴承盖的开发

Problems of falling chip, tool tipping and big noise are happened during cutting off main bearing caps made of gray casting by using combination milling cutters.

采用组合铣刀切断灰口铸铁材质的汽车发动机主轴承盖时 ,出现工件掉渣、刀具崩刃、噪声大等问题。

The characteristic analysis of the suspended main bearing cap of SL4105 diesel engine was presented by using the 3D solid modeling,3D mesh generation,external loads & boundary condition and 3D finite element analysis.

介绍一种运用三维实体造型、三维网格划分、载荷和约束处理及三维有限元分析的方法,对SL4105柴油机悬挂式主轴承盖进行了强度和刚度分

The bottom bearing applies both labyrinth seal and frame seal, which have good performance of sealing. The main shaft is anticorrosive.

下轴承端盖密封采用双重密封，可确保密封效果，主轴采用防腐新技术，能保护主轴免受腐蚀。

Permanently sealed and lubricated ball bearings front and rear.

前后端盖装有永久密封和自润滑的滚珠轴承。

Remove the lower insert from the bearing cap.

从轴承盖上拆去下轴瓦。

Install the lower bearing inserts into the main bearing caps.

安装下轴瓦到主轴承盖。

Analysis and Solution of Endshield-type Oil Leakage in High-Speed Motor

高速端盖式滑动电机轴承漏油问题的分析与解决措施

end shield bearing

机油滤清器内盖头轴承

fan end thrust ball bearing

风扇端止推滚球轴承

SMALLER DIAMETER OF PIVOT BEARING

轮毂轴承的较小直径端

End play in drive pinion bearings.

驱动小齿轮轴承的端隙。

Analysis and solution of cramped shield to be detachable in sealing bearings

带卷边防尘盖轴承活盖问题解决办法

Pressure-compensated air bearings are used on both ends of the trunnion axis.

耳轴两端各用一压力补偿空气轴承。

hub cap for road motor vehicles or tractors

轴端盖,道路机动车辆或摩托车用

Measures for improving the concentricity of the bearing s minor hole at the two ends;

提高套筒两端轴承档内孔同轴度的措施

Spherical plain bearing rod ends-Boundary dimensions and tolerances

GB/T4222-1991杆端关节轴承外形尺寸和公差

Spherical plain bearing rod ends-Boundary dimensions

GB/T9161-1988杆端关节轴承外形尺寸

automatic grinding machine for end face of needle bearing ring

自动滚针轴承套圈端面磨床

Embedded Bearing Fault Diagnosis System DSP Side Design;

嵌入式轴承故障诊断系统的DSP端设计

Measurement of Dynamic Stresses and Temperatures of Main Bearing Walls and Caps on an Engine Block

发动机缸体主轴承座及主轴承盖的动态应力和温度测量