single bend test

用法例句

The purpose of weld guide bending test is to detect plasticity of welding joint,welding process and surface defects of materials.

焊缝导向弯曲试验的目的是检查焊接接头的完好性和塑性以及材料的焊接工艺和表面缺陷。

Figure 3, 4 shows a flat piece of metal that has been through an angle of 180. Sheet metal may be given a single bend test

图3．4表示一片金属扁试样被弯曲180°可以对薄板金属进行单向弯曲试验，

Test methods for bare wires--Bend test--Single bend test

GB/T4909.6-1985裸电线试验方法弯曲试验单向弯曲

alternative wrap around guided-bend test

交变缠绕定向弯曲试验

Test method for flexural properties of unidirectional fiber reinforced plastics

GB/T3356-1999单向纤维增强塑料弯曲性能试验方法

Research on Bending Rotation Test of Rotation Shaft in Point the Bit Rotary Steerable System

指向式旋转导向系统旋转轴弯曲旋转试验研究

fine ceramics(advanced ceramics, advanced technical ceramics)-test method for flexural strength of monolithic ceramics at elevated temperature

细陶瓷-单块陶瓷高温弯曲强度试验方法

flexing ozone weather testing chamber

臭氧腐蚀弯曲试验箱

testing method for flexing endurance of light leathers and their surface finishes

皮革耐弯曲性试验方法

testing method for flexural creep of plastics

塑料弯曲蠕变试验法

rotary bending tester

旋转弯曲疲劳试验机

rotating bending fatigue machine

回转弯曲疲劳试验机

reversed bending fatigue machine

反复弯曲疲劳试验机

Test methods for bare wires--Bend test--Reverse bend test

GB/T4909.5-1985裸电线试验方法弯曲试验反复弯曲

With data obtained from low temperature bending and bending creep test, a simple calculation method is given for calculating rupture energy.

应用低温弯曲和弯曲蠕变试验所得数据,给出了破坏能的简单计算方法。

Methods of test for enamelled wires--Mandrel winding test for rectangular wires

GB/T4074.7-1983漆包线试验方法扁线弯曲试验

fine ceramics(advanced ceramics, advanced technical ceramics)-determination of fracture toughness of monolithic ceramics at room temperature by the surface crack in flexure(scf) method

细陶瓷-单块陶瓷常温断裂韧度试验方法-弯曲表面龟裂法

Plastics--Determination of flexural properties by use of small specimens

GB/T16419-1996塑料弯曲性能小试样试验方法

INFLUENCE OF HOLE POSITION ON BENDING RIGIDITY OF UD-LAMINATE

穿孔位置对单向层板弯曲刚度的影响